BELTING: 1/2″ x 1″ x 11 ga. clinched edge, galvanized wire mesh belt.
DRIVE SPROCKETS: 4″ dia. sprocket with 1-3/16″ dia. shaft or 8″ dia. sprocket with 1-7/16″ dia. shaft.
TAIL SPROCKETS: 4″ dia. sprocket with 1-3/16″ dia. shaft.
END DRIVE: One-direction unit operation.
TAKE-UP: Screw type unit at tail end provides 12″ belt take-up.
RETURN ROLLERS: 1.9″ dia. x 16ga. steel, model 196S, adjustable.
BED: 7″ x 1-1/2″ x 10 ga. formed channel frame with UHMW wear strips.
FLOOR SUPPORTS: Optional.
BEARINGS: Drive and tail shaft bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.
BELT SPEED: 60 FPM, constant.
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: Drive shaft is driven by No. 50 roller chain for 1-1/2 HP or less and No. 60 chain on larger drives. Chain take-up provided on motor base.
Roach wire mesh belt conveyors can be used in a
variety of conditions to convey hot, cold or oily products in oven,
cooling or other special conditions.
BELTING: High carbon, stainless
steel, others available. Consult factory.
SPEED: Constant speed 1.5-60
FPM; DC variable speed; AC inverter variable speed. Other
constant or variable speeds available. NOTE: CAPACITY
CHANGES WITH SPEED.
MOTORS: Available through 2 HP in
TEFC, explosion proof, dirty duty, 115/230/1, 575/3, etc.
FLOOR SUPPORTS: Supports,
knee braces, casters, and polytier supports available. See Conveyor
Accessories.
ELECTRICAL CONTROLS:
Magnetic or manual starter; limit switch;
others available.
