TREAD ROLLERS: 1-3/8″ dia. x 18 ga. galvanized steel, model 138G w/ 5/16″ hex, grooved.
DRIVE BELT: 1/8″ dia., polyurethane belts. Nominal 10 lbs. per roller drive.
DRIVE SHAFT: 1″ dia. C1018 cold rolled steel shaft.
COUPLINGS: Couplings located both ends (type “A”), one end only (type “B” or “C”) or none (type “D”).
CENTER DRIVE: Reversible drive; located approximately 18″ from end of bed section for 3″ and 6″ RC; 16-1/2″ for 4″ RC.
BED: 7″ x 1-1/2″ x 12 ga. formed steel channel frame. Bed sections attached w/ splice plates and floor supports.
SPEED: 60 FPM, constant.
FLOOR SUPPORTS: Optional
BEARINGS: Precision, lubricated, ball bearing units with composite housings.
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base.
ELECTRICAL CONTROLS: Optional
OPTIONAL EQUIPMENT
SIDE MOUNTED DRIVE: With 10” minimum elevation.
FLOOR SUPPORTS: Supports, knee
braces, casters, polytier supports
& ceiling hangers available. See
Conveyor Accessories.
SPEED: Constant 15-120 FPM,
or variable (specify). MINIMUM
operating speed for line shaft
conveyor is 30 FPM. NOTE: CAP
ACITY CHANGES WITH SPEED.
MOTORS: Available through 2 HP
in TEFC, explosion proof, dirty duty,
115/230/1, 575/3.
ELECTRICAL CONTROLS: Manual
start/stop push button switch;
magnetic starter; others available.
