TREAD ROLLERS: 1.9″ dia. x 16 ga. steel, model 196S grooved.
DRIVE BELT: 3/16″ dia., polyurethane belts. Nominal 15 lbs. per roller drive.
DRIVE SHAFT: 1″ dia. C1018 cold rolled steel shaft, located on inside radius.
COUPLINGS: Couplings located both ends (type “A”), one end only (type “B” or “C”) or none (type “D”).
BEARINGS: Precision, lubricated, ball bearing units with composite housings.
CENTER DRIVE: Reversible drive; located approximately 18″ from end of bed section for 3″ and 6″ RC; 16-1/2″ for 4″ RC.
BED: 7″ x 1-1/2″ x 12 ga. formed steel channel frame. Bed sections attached with splice plates and floor supports.
ROLLER CHAIN: Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base.
FLOOR SUPPORTS: Optional
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ELECTRICAL CONTROLS: Optional