TREAD ROLLERS: 1.9″ dia. x 16 ga. steel, model 196S grooved.
DRIVE BELT: 3/16″ dia., polyurethane belts. Nominal 15 lbs. per roller drive.
DRIVE SHAFT: 1″ dia. C1018 cold rolled steel shaft.
COUPLINGS: Couplings located both ends (type “A”), one end only (type “B” or “C”) or none (type “D”).
CENTER DRIVE: Located approximately 16-1/2″ from end of bed section on 4″ RC; 18″ on 3″ and 6″ RC.
BEARINGS: All pulley bearings are precision, heavy duty, lubricated, ball bearing units with cast iron housings.
ACCUMULATION: Zone singulation operation; 2′-0″ zone length, photoeye controlled.
SPEED: 60 FPM, constant.
BED: 7″ x 1-1/2″ x 12 ga. formed steel channel frame. Bed sections attached with splice plates and floor supports.
FLOOR SUPPORTS: Optional
MOTOR DRIVE: 1/3 HP, 230/460/3, 60 cycle, ODP right angle gear motor.
ROLLER CHAIN: Drive shaft is driven by No. 50 chain. Chain take-up provided on motor base.
ELECTRICAL CONTROLS: Optional
SIDE MOUNTED DRIVE: Provides overall
conveyor height of 10”.
ACCUMULATION ZONES: 18” and 30”
long zones available, depending on roller
centers.
FLOOR SUPPORTS: Supports, knee brac-
es, casters and polytier supports avail-
able. See Conveyor Accessories.
CEILING HANGERS: 5/8” dia. threaded
rod with hardware to attach rods to
conveyor. Provides 6’ clearance between
ceiling and TOR (furnished in place of
floor supports). See Conveyor
Accessories.
CONVEYOR SPEED: Constant speed
15-120 FPM; DC variable speed; AC
inverter variable speed. MINIMUM
operating speed for line shaft conveyor
is 30 FPM.
SLUG RELEASE: Products may be slug
released rather than individual product
release in normal zone singulation;
accumulation mode will not be disturbed
when slug release option utilized.
GALVANIZED ROLLERS: Tread rollers
available in galvanized steel, model
196G grooved.
MOTORS: Available through 2 HP in
TEFC, explosion proof, dirty duty,
115/230/1, 575/3, etc.
DEFUSED SMARTZONE: Photoeyes
mounted below tread rollers.
